The Balboa VS100 Circuit Board G1110 is the replacement for the 56298-01/-02, 56297-01/-02 and base 56299-01/-02. This circuit board is only compatible with the standard four button Balboa VL200, VL240 or VL260 topside control panels that have the temperature up and down buttons on the right side of the topside.
Details:
- Balboa P/N: G1110
- Voltage: 115v / 230v
- Power Requirements: GFCI Protected Service, 3 Wire 115v, 4 Wire 230v
- Neutral Required: Yes
- Pumps: Can run 1 x 2 speed pump 115 volts only
- Heater: 1KW @ 115v, 4KW @ 230v
- Circuit Breaker Rating: 20A on 115v & 50A on 230v
- System Series: Balboa VS100
- Configuration: 1 Pump, Ozone, 12v Light
Important
This circuit board is not a compatible replacement for any custom VS100 that runs a 230 volt pump and is wired direct to 230 volts without a white neutral or the Dream Maker RS101 456401, RS81 356796 or Spaberry 56439. Do not purchase a replacement Balboa circuit board on appearance alone, a number of the Balboa circuit boards look the same but have different software or operating chips on them and they are not interchangeable.
Returns:
Hot Tub circuit boards are non-returnable items as they cannot be resold. All the replacement circuit boards we sell are factory-new, factory-tested and have never been installed before. For further information, please refer to our return policy. All circuit boards come with the original manufacturer's warranty.
Warranty Coverage: Balboa circuit boards come with a six (6) months limited manufacturer's warranty from the date of purchase that covers defects in workmanship and materials. This warranty will be void if these parts are damaged due to improper installation or use or if the damage is from exposure to water or electrical power surges. The warranty does not cover any labour charges, the cost of lost water or chemicals, or any other possible damages.
IMPORTANT. Terminal block screws need to be tightened to torque to the specs listed on the inside cover of the pack. Failure to tighten properly can cause heat/resistance arc burn damage to the circuit board. The manufacturer will not honour the limited product warranty if these connection points are burned.
