Categories

Waterway Executive Pump Face-plate 2" 311-1220

$40.99 - $54.07
(1 review) Write a Review
SKU:
311-1220
Brand:
Condition:
New
Availability:
Usually ships in 1-2 days
Shipping:
Calculated at Checkout

Waterway Executive Pump Faceplate with 2" Suction Inlet

  • Waterway part #311-1220
  • Made in the USA by Waterway Plastics
  • Actual measurement of the intake is approximately 3" across the outside of the threads. Always measure your existing faceplate as the same part number can also be found on a 2.5" faceplate.
  • Faceplate does not include drain plugs, barb fittings, or o-rings.
  • Drain plugs with o-rings are sold separately if required.
  • Some pumps may have a small hose instead of one of the drain plugs which would require an additional barb fitting

 

  • NOTE: Waterway changed the design of this faceplate in late 2017. The part number remains the same however the new design requires TWO large o-rings instead of the old design which only used one. The faceplate o-rings are not included, part #805-0261 is sold separately and this faceplate requires a total of TWO. 

1 Review Hide Reviews Show Reviews

  • 4
    Great Replacement Part

    Posted by Chris on 24th Sep 2013

    My pipes and pump froze during the winter and the face-plate burst around the seam of the outside edge of the ring around the threaded area. When it thawed all my water leaked out. I bought this part and it is a perfect replacement. I was able to use the old plugs, rubber gasket ring, and screws. I had to apply some gasket lube / sealer. So far no leaks. Would have been nice if it came with new plugs,rubber gasket,and screws, but that's my only beef.