4.5HP Waterway Executive 48 Pump, 2 Spd, 2.5" - 2", PF-45-2N22C4


Price $569.09
(You save $29.91 )
4.5HP Waterway Executive 48 Pump, 2 Spd, 2.5" - 2", PF-45-2N22C4
Adding to cart… The item has been added
Don't Leave Without These!
Store Address
Order Online
Pick Up In-Store
195 Exeter Rd, London ON, Canada
Store Shipping
Standard Shipping:
Free Shipping* Usually leaves warehouse in 1-3 business days
  • 4.5HP Waterway Executive hot tub pump, 2 Speed 48 frame,
  • Waterway OEM part # 3421821-13, - #PF-45-2N22.  
  • 2-1/2"" intake and 2.0" discharge, See bottom of page for important sizing guide
  • 220-240volt,
  • 12.0 Amps high speed (3450 RPM)
  • 3.5 Amps low speed (1725 RPM). 
  • New cord and unions not included, sold separately.
  • PLEATE NOTE: This pump is not a compatible replacement for the PF-45-2N22C used in Beachcomber hot tubs. This is a smaller 48 frame pump, the PF-45-2N22C in Beachcomber hot tubs is a 56 Frame model, sold here



The PF- model number from your old pump should not be used as a reference for selecting a new replacement pump as Waterway has produced up to 4 known variations of pumps with the same model number which are different enough that they are not interchangeable. Always select a replacement pump with the same part number as the Waterway part number on the label on your old pump.


Horsepower ratings

Choosing a pump based on Horsepower (HP) can be incorrect. The horsepower listed in your spa manual or on the old pump's label may be overinflated, inaccurate, or even left blank. Horsepower ratings on hot tub pumps are often listed as SPL-HP, BHP, MBHP, RHP or S-HP, which is not the same as continuous operating horsepower. Installing an oversized pump in your hot tub can cause significant damage.

To avoid choosing the incorrect pump, confirm if it’s a 48 frame or 56 frame, then use the high-speed Amperage rating listed on the old pump's label to find the correct replacement instead of the horsepower. The amperage rating is listed with both high/low speed for a 2-speed pump.


Determining hot tub pump thread size

Hot tub pump plumbing sizes are nominal and not the actual outside diameter (O.D.) of the threaded intake or discharge. To confirm your old pump thread sizes, use a tape measure and check the diameter of your old pump thread size.

  • 1.5” Pump thread measures approx. 2-3/8” Outside Diameter
  • 2.0” Pump thread measures approx. 3” Outside Diameter
  • 2.5” Pump thread measures approx. 3-5/8” Outside Diameter


Amperage ratings

New hot tub pump amperage ratings may vary slightly for pumps with the same performance rating. The RPMs remain the same 3450 for high-speed and single-speed pumps and 1725 for low-speed for two-speed pumps.

Manufacturers 1 year limited warranty.

Product Reviews