Waterway hot tub pump with a centre discharge on top which is rated at 1.5 HP running on 115 volts, this is a common model pump used in many spas which operate on 115 volts. When replacing a Waterway spa pump always replace the old model with a compatible equivalent model to ensure your spas performance remains the same.
Pump details:
- 1.5 HP Waterway centre discharge hot tub pump, 2 Speed 48 frame,
- Waterway OEM part # 3420610-15,
- 1.5" intake and 1.5" discharge,
- 110-120volt, 13.3 Amps high speed (3450 RPM) and 4.1 Amps low speed (1725 RPM).
- Viton pump seal for ozone and salt hot tubs
- New cord and unions not included, sold separately.
Orientation of wet end.
Pump discharge can be oriented in 90 Degree increments, up, left or right as shown, will ship with discharge directed up.
Important
Determine the pump plumbing size by measuring the outside diameter of the wet end male threads. Plumbing sizes for hot tubs are nominal, and not actual outside diameter (O.D.) of the the threaded intake or discharge. Once you have removed the pump, use a tape measure to check your old pump thread size and compare to the sizes below.
If your pump thread O.D. is (approx.) 2 3/8", Then you'll need a pump with union size 1 1/2".
If your pump thread O.D. is (approx.) 3.0", Then you'll need a Pump with union size 2.0".
If your pump thread O.D. is (approx.) 3 5/8", Then you'll need a Pump with union size 2 1/2".
If your pump thread O.D. is (approx.) 3.0", Then you'll need a Pump with union size 2.0".
If your pump thread O.D. is (approx.) 3 5/8", Then you'll need a Pump with union size 2 1/2".
Please note!
Some brands of hot tub spa pumps have non-standard threads and use fitting sizes with different dimensions. These brands are: Hayward, Jacuzzi and sta-rite.
Some brands of hot tub spa pumps have non-standard threads and use fitting sizes with different dimensions. These brands are: Hayward, Jacuzzi and sta-rite.
Manufacturers 1 year limited warranty.
