Replacement Balboa Circuit Board P/N 52295 for the older digital 2000LE control system. This circuit board uses a pressure switch to monitor water flow.
Details:
- OEM part number 52295-01,
- Chips 2002LER1 or 2000LER1,
- Can run:
Pump 1 - Dual speed,
Pump 2 - Single/Dual Speed,
Blower,
Circulation Pump,
Ozonator,
Either 12V Spa Light or 120V Fiber Optic Lights - Maximum 5.5 kw heater.,
Please note:
Only works with the following Balboa Topside Panels: 53189, 54156, 51247, 51057, 51452, 54157, 54170.
Compatible parts:
- 30352 Balboa Temp Sensor,
- 32016 Balboa Hi-Limit Sensor,
- 58019 Heater Assembly,
- 3902 or 4010P Pressure Switch,
- 30039 or 30511 Copper Heater Straps.
Returns:
Hot Tub circuit boards are non-returnable items as they cannot be resold. All the replacement circuit boards we sell are factory-new, factory-tested and have never been installed before. For further information, please refer to our return policy. All circuit boards come with the original manufacturer's warranty.
If you’re not sure which board is the correct replacement for your spa, please call us 1-877-845-1993 or text us a picture of your old circuit board 548-488-4942 and we’ll help.
Warranty Coverage: Electronic circuit boards come with a six (6) months limited manufacturer's warranty that covers defects in workmanship and materials. This warranty will be void if these parts are damaged due to improper installation or use or if the damage is from exposure to water or electrical power surges. The warranty does not cover any labour charges, the cost of lost water or chemicals, or any other possible damages.
IMPORTANT. Heater and terminal block screws need to be tightened to torque to the specs listed on the inside cover of the pack. Failure to tighten properly can cause heat/resistance arc burn damage to the circuit board. The manufacturer will not honour the limited product warranty if these connection points are burned.
